BartPE Plugin for TI 2009 Will Not Install-previous TI 12 required
Cannot use the BartPE installer TrueImage2009Addons_s_en.exe
The installation is interrupted and the report indicates that TI Home 12.0.9809 must be previously installed. I have never owned TI ver.12. My TI 2009 was purchased as an upgrade of TI ver.11
I am keen to use my new BartPE USB that was painstakingly created recently. Would be great to get to use TI with Bart.
What to do??
I am attaching a snip of the installer report window after failure...
-regards.
Allegato | Dimensione |
---|---|
acronis.PNG | 52.54 KB |

- Accedi per poter commentare

Yes, I am using the latest build #9809 of TI 2009. Thank you for that information:
"V12 is the original never used name for 2009 version."
It allows a bit more clarity as to what the nature of this problem may be. I looked about the TI Home forum but cannot see anything just like this. The TI 2009 is up to date as I assume the Bart installer is.
I shall keep fingers crossed for more help here. Thank you much for your reply.
-Randy
- Accedi per poter commentare

o.k. I found the solution. The addons(BartPE+) installer worked fine after I used the TI 2009 installer to "modify" my install by adding the rescue media builder. I didn't need that feature on original install. Would be nice to see a note on the rescue media install when the addons installer balks!
-nice to have TI 2009 on BartPE.
But I can't see the hard drives using BarPE on the laptops here. But that's for a Bart forum...
- Accedi per poter commentare