Salta al contenuto principale

Valid Backups turn "Bad" over time

Thread needs solution

I use TI 2018 to backup my system. I always validate the backups and then disconnect the external disk until the next backup. TI says the backups are good. Later (weeks) I get random notices from Acronis saying that an operation failed. What operation? I don't have the backup drive connected and I am not running TI. To top this off TI will also say that my previously saved (and OK) backups are bad. I hook up the external disk and run verify, and then TI is happy again.....until the next occurrence of this event.

I experience the same thing back under TI 2016.

 

Any insights?

Allegato Dimensione
TI 2018 - 2018-12-17_12-25-56.png 63.53 KB
0 Users found this helpful

The screen image would suggest to me that this backup task was scheduled to run but gave the error because the destination drive was not connected.

If you are not keeping the backup drive connected, then you should also remove any schedules unless you have a reminder setup to have you reconnect the drive prior to the scheduled time.