Pri,Act. fix
OS=W7
current drive 2TB - 100MB, 80GB, 853.4GB, 931.5GB
test drive 1TB - 100MB, 80GB, 853.4GB
I created a backup of my C: drive. 80GB
I then partitioned the test drive using my W7 disk as above so both C: and target = 80GB
I performed a restore to the test drive checking MBR also and telling it to set it active.
It would not boot - BOOTMGR missing.
I used my W7 disk to repair that. All is fine (almost).
The test drive has the system reserve partition set as Pri and the C: partition set as Pri,Act.
the current drive is the opposite.
So when I boot to the test drive the reserved partition is visible.
Two questions:
1. what did I do wrong such that I had to fix the BOOTMGR missing issue?
2. How do I swap those status and make the reserved partition invisible when booting to the test drive.
Extra point question;
the current drive has unreadable errors on 5 sectors. I ignored them. The question is, were just those 5 sectors not copied to the backup, or were the files associated with the bad sectors not copied?
thx
- Accedi per poter commentare