boots from disk but will not display
When I use the rescue disk to boot it goes threw the boot process but when it is done loading my monitor is black? Any ideas for trouble shooting

- Accedi per poter commentare

Mooly wrote:Do you see the Acronis logo as it begins to boot off the disc ?
Yes 1st it shows 32 bit or 64 choose what one then next screen it goes top left loading Acronis flickers to next screen copy right etc then next screen black?
Maybe I should up plug for third party video card and plug it into integrated video card on motherboard?
- Accedi per poter commentare

I'm afraid I've no real answer to that but I was curious because I've experienced something similar with TI2012 and TI2014. The bootable media loads with the Acronis splash screen and then it hangs at the 'Starting Acronis Loader' page. The only way out was a forced shutdown and to try again. Sometimes it would boot OK and other times it would repeat and hang.
- Accedi per poter commentare

I have the same problem. Appears to be working then the monitor shuts down/sleeps.
I get 'Starting Acronis Loader' then I select 'Acronis True Image 2016', which is followed by a pixelated 'Acronis True Image 2014' screen with a bunch of patent numbers, then about 20-30 seconds later the screen goes blank, get 'no signal' message and the PC hangs.
I've tried CD media and USB media with the same results. Tried my original True Image 2011 OEM disk and it booted properly. Chat was not much help.
Mike
- Accedi per poter commentare

yea I miss TI 2013 always work nerver failed !! ended up just format reinstalled sad to say losing hope TI going backwords sad was good at one time
- Accedi per poter commentare

Hi Sjea!
I am sorry to hear that you have experienced such problems with the software.
The issue with the bootable CD can have several causes:
1. There was an error during the creation of the Media
In that case, please, just recreate the media.
2. The UEFI is blocking the boot process
If you have UEFI, please, disable the FastBoot and the SecureBoot to make sure, that the issue is not related to that.
3. The media lacks some essential drivers for the hardware
This can occure if your chipset or the hard drive have some drivers that can't be installed on the default media. In that case, please, create the WinPE Bootable Media.
Hope that helped!
- Accedi per poter commentare