Salta al contenuto principale

Cannot now select destination drive!

Thread needs solution

I deleted a backup of my system drive as it had been reported by ATI as corrupt. I then attempted to setup another system backup so as to 'start over' again. I forgot to do a clone of the settings (would that make any difference?) but now, having selected the partitions to backup I am unable to select any destination. I click on 'select destination' but nothing happens!

I have uninstalled and re-installed ATI but still get the same result. I'm assuming that it is to do with deleting the corrupted backup but that is only my guess.

0 Users found this helpful

Hello Vlad the Inhaler,

Could you check this article? https://kb.acronis.com/node/60680

Based on the description, I would think that you have faced this issue.

Hello Renata, thanks for the prompt reply!

Yes, you are right, although it took a lot of clicking outside of the green box to find the 'magic spot'!

I had no problems until I deleted the previous backup so it was odd to see this happening.

But at least I can now continue with my backups!

Thank you.

Kind regards.