Bootmgr not found after ATIH install

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Messaggi: 1
Commenti: 1

I just installed ATIH 2010 on a new windows 7 PC. The install appeared to go well and Acronis said that the system needed to be rebooted to Acronis to work. I rebooted the system and lo and behold I get a message "Bootmgr cannot be found".
What can I do to "unscrew" what the software install has done?
Thanks.

Sab, 04/10/2010 - 00:42
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Messaggi: 1
Commenti: 1

I am unable to boot to the Windows 7 install disk. Apparently the acronis install took out that capability too.

Sab, 04/10/2010 - 00:58
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Messaggi: 45
Commenti: 4263

Installing TI shouldn't have changed the booting drive or the Active partition.

Have you verified that the correct drive is still set as the booting drive in the BIOS and that the correct partition is set Active?

If you're trying to boot the Windows 7 DVD, make sure the DVD drive is set to boot before the hard drive or use the BIOS Boot Menu (if available) to select the device/drive to boot at startup.

Sab, 04/10/2010 - 05:49