Salta al contenuto principale

Cloning my SSD to two SSD's in raid 0, acronis loader doesn't start back up after reboot.

Thread needs solution

After reboot POST then It says starting acronis loader, but screen stays black.  Q code on Motherboard reads FF.

0 Users found this helpful

I am not sure if ATI is capable of performing the clone from an SSD to a RAID.  I believe the only way to accomplish is to perform a backup of the SSD to another hard disk (perhaps a USB hard drive), then perform a restore from the USB hard drive to the RAID.  This would all have to be accomplished under Windows.  The backup would have to be a disk mode/full partition list backup.

I have never done this, this is just my "best guess".

Regards,

FtrPilot