Salta al contenuto principale

Cloning with True Image 2012 build 7119

Thread needs solution

Following Scenario:
Three 500GB disks in a Raid0 on a LSI slot-in controller. I try to clone this array on a 2TB disk.
The disk is completely empty.
Perform the cloning with TI2011 (last build) works without a problem.
With TI2012 build 6154 I get the same result.
But if I try to perform the same steps with TI2012 build 7119 or TI2012 build 7119 with included pluspack I get the error message that the files cannot be moved. I should verify if the new drive
has enough space or if the volume has errors.
A smart check couldn't detect any error.
The message occurs only if I select the "manual" option, where TI should not change any size of the partitions and leave the rest space unused on the target drive.
If I select the "automatic" option where TI can grown the target partitions to use all space on the target drive, it works too.

I think there is a little bug in the release 7119.

Have someone any idea how to fix this problem.

Kind regards
Martin

0 Users found this helpful

Just a few notes:
automatic: program will proportionately expand some partitions and some it will leave alone. No user control over sizing. Depending upon how your partitions are configured, it may guess right or it may guess wrong. If the partition is the active partition, it will probably not resize.

Manual: move method= "as is".
    Result is A replica of the old disk with any extra space unallocated.

Manual: move method=manual.
   Program will initially set the same proportionately size partition --same partition sizes as automatic. In the manual move method, user will need to undo the initial proportionate size setting and adjust partitions size and set active, etc to their own specifications. Everything is manual.

I am not familiar with Raid so unable to help you.