data1.cab file missing or damaged
Trying to install a trial of Acronis True Image 2014. So here's what I get:
"Installation has failed.
Fatal error during installation
The cabinet file 'data1.cab' required for this installation is corrupt and cannot be used. This could indicate a network error, an error reading from the CD-ROM, or a problem with this package."
I've tried turning off anti-virus or firewall software that could be preventing if from installing correctly. Also tried downloading it again several times, and I still get the same error.
I'm trying to install it on a Sony VAIO, model PCG-4F1L from 2001. It's small, slow and terrible. I'm hoping that's not the cause of the issue, because my employers want it on this computer specifically.
Any ideas? Thanks.
Trying to install a trial of Acronis True Image 2015.
So here's what I get:
"Installation has failed.
Fatal error during installation
The cabinet file 'data1.cab' required for this installation is corrupt and cannot be used. This could indicate a network error, an error reading from the CD-ROM, or a problem with this package."
...
http://www.symantec.com/
ERROR: Error 1335.The cabinet file 'Data1.cab' required for this installation is corrupt and cannot be used. This could indicate a network error, an error reading from the CD-ROM, or a problem with this package.
[Solved] Solution to Error 1335 'cabinet file Corrupt'
by Papasmurf60 » Wed Nov 20, 2013 11:55 am
Solution: Change the memory settings for installation
When loading Aoo4.01 I was receiving the following message: ERROR 1335. The cabinet file 'openoffice1.cab' required for this installation is corrupt and cannot be used. This could indicate a network error, and error reading from the CD-ROM, or a problem with this package.
This is a/the solution to the problem. Change the memory setting for installation.
To change the memory settings for installation, follow these steps:
Click Start, and then click Run.
In the Open box, type msconfig, and then click OK.
On the BOOT.INI tab, click Advanced Options.
In the BOOT.INI Advanced Options dialog box, select the /MAXMEM= check box, and then change the setting to 256 (or lower if your computer has less RAM).
Click OK to close the BOOT.INI Advanced Options dialog box.
In the System Configuration Utility dialog box, click Apply.
Click OK to close the System Configuration Utility dialog box.
Click Restart to the following message:
You must restart your computer for some of the changes made by System Configuration to take effect.
After you restart your computer, install Office as a Complete Install.
After you install Office, follow steps 1 through 8 to clear the /MAXMEM= check box.
It is a slow loading procedure and you may think it's stopped. BE PATIENT, It will be working