Salta al contenuto principale

TI 2010 w/ Plus Pack Build 7046

Thread needs solution

I noticed today that new versions of TI 2010 and the Plus Pack were released. I installed TI 2010 first and allowed it to reboot, then installed the Plus Pack. However, the splash screen and About dialog make no mention of the Plus Pack being installed. I re-ran the Plus Pack installer and had it do a Repair, and that made no difference.

Should I try uninstalling both products and start over? I don't want that to mess up my activations.

0 Users found this helpful

So rather than waiting for a response I decided to take a gamble and uninstall first the Plus Pack and then TI 2010, and finally reinstall them from scratch. To my disappointment, there still is no indication that the Plus Pack installed successfully.

 I don't think I'm doing anything wrong -- my first attempt to update to build 7046 followed the steps in the KB article. Even if that didn't work, I would think uninstalling and reinstalling would have done the trick. Is build 7046 of the Plus Pack just plain broken?

Torsten-

This sounds very similar to this thread: http://forum.acronis.com/forum/9752

Sorry that I can't offer an answer, but this thread describes an alternative you could try. I have build 6035 with Plus Pack that works fine from all bootable media. I would see if it works via bootable media.