Validate backup on NAS takes a long time
I have a couple computers running TI 2013, backing up to a Synology 1812+ NAS. The backups run pretty quick, but validation takes forever.
For example, the differential backup this morning ran from 9:10 to 9:24, but then the validation did not finish until 5:09, so pretty much 8 hours.
On Monday a 5 minute differential backup took 2 and a half hours to complete
I am going to have to turn validate off, which I don't want to do. Any ideas on a Solution?
Thanks
Doug
- Accedi per poter commentare
Thanks for the quick response.
Yes there are a couple backups in that directory. 1 backup of 365 GB with 4 differentials of 4GB each, and then the full and 1 differential from the new set.
I have copied these first set to a different directory.
Any way to tell Acronis to only validate the backup it just did rather than everything else?
These computers are running Gig ethernet plugged into a HP Gig switch, port are all running at GB with FDX.
Is there a way to have Acronis create a new directory whenever it starts a new backup set after it hits the 5 backups to a set limit that I set?
I am pretty impress with the Synology NAS for speed, I often see 400+Mbs transfers
Would the Acronis workstation 11.5 version of the product help at all? I would buy it if there was something there that helped.
Thanks
- Accedi per poter commentare
To answer your query about starting a new folder, have a look at the batchfile utility called Chaingen. Have a look at item #5 in Grover's Guides, link in the left hand margin of this forum.
Validation with ABR11.5 won't be much faster, you could install the trial version of ABR11.5 and see if there is an improvement in speed, but it can't read True Image files, so you would have to make a complete new archive. ABR11.5 doesn't make new folders on a full either, but it does have a command line utility. I haven't checked but it might be possible to do what you want that way.
- Accedi per poter commentare