Salta al contenuto principale

Validation after backup doesn't seem to work with ATIH 2012

Thread needs solution

When I perform a full partition backup I always select the option to validate the backup after creation. It appears like ATIH2012 is performing the backup and then stopping without performing the validation. If you go back and verify the backup manually then, and only then, the line that says the backup is valid appears. The ability to view the log for the backup is also missing from the item on the backup list. I have attached a snapshot showing the options that were selected and the resultant backup list showing the latest backup with the missing validation line.

Hopefully one of the Acronis developers will see this and take some action to get it corrected. Validation is a very important part of the backup process and I find it difficult to believe that the software made it to RTM without this function being thoroughly tested.

My system has a I7-950 processor in a ASUS X58 Sabertooth motherboard running on Windows 7 64 bit with the latest SP1 installed.

Allegato Dimensione
backup_list.docx 568.79 KB
options.docx 629.89 KB
0 Users found this helpful

After further analysis it appears like the validation is being performed so this may be a case where the screen is not being refreshed to reflect the validation status.

Check what log file shows. This is 2012-6131