Salta al contenuto principale

Validation Issues

Thread needs solution

I just downloaded True Image 11. Once installed I imaged the hard drive. Then I tried to validate it but nothing is happening. It goes thru the validation process and it finished but I never get that little message under the archive that says "back up validated". I've vallidated 3 or 4 times and the same thing happens each time. The validation process completes with no errors. I check the log and it says validation process complete but I never get that verification message under the archive. What is going on here? Why is this happening? Mind u this is happening on a fresh Windows 7 install.

0 Users found this helpful

Hi there,

The banners in the backup list do not refresh as you would expect upon successful validation (You don't get the "Backup is valid" banner). This is a bug/design issue with TI 2011.
Best thing is to check out the log as you did.

So in other words it is a valid image and the banner not showing up does not indicate the image is corrupt? So can I assume as long as the imaging and verification process complete successfully according to the log that it's a valid image whether or not the banner is displayed?

Correct. If you look at the log, you will see the validation step at the end, and it will tell you whether it properly validated or not.
In my case, I run validations after backups, and I have an email sent out if there is a problem.

Personally, I would like to see the banners update in the UI to tell you that the backup has completed and it is valid. Hopefully this is something Acronis will fix.