[RESOLVED] snapman.sys BSOD of latest build of TI 2013
I get frequent BSOD from snapman.sys. I have the latest build of TI 2013. I see lot's of older forum messages about this but can't find a search that shows it with 2013.
I'm using a Lenovo laptop. I love TI 2013 and its ability to quickly backup and restore.
I'd hate to have to stop using it. Is there a solution to the snapman.sys BSOD?
I don't need scheduled backups. I've tried disabling all accronis startup and services so that I can use them only when I want ot backup or restore. It doesn't help. Snapman.sys still causes BSOD 50% of boots.
Thanks,
-michael
Issue resolved here.
- Log in to post comments
I have been experiencing the same. Have had 4 bluescreens since update. I wasn't sure if it was Acronis but they started after the upgrade. I'm running Windows 7 64bit on Desktop Gigabyte 965P-DQ6, Intel Core 2 Duo E6600, KINGSTON SVP200S3240G SSD and snapman.sys v4.4.0.1059 or Product v4.4 build 1059 TI uses high cpu while running and doing nothing.
I have been trying to create a support request 5 times now doesnt seem to work. Hope we have a solution soon very frustrating. Should I downgrade?
- Log in to post comments
Uninstall 2013, use the cleanup utility found here, reboot reinstall.
http://kb.acronis.com/content/34876
- Log in to post comments
Hello Everyone,
Thank you for your posts and your help Colin and Pat.
For BSOD related issues I would recommend contacting our Support team so that we can assist you. Please include the following information:
1. BSOD message.
2. AcronisInfo report.
Rob, could you let me know if you have tried the following way for contacting our support and let me know your exact steps if you experience another issues with getting through to our Support team.
Please let me know if you have additional questions.
Thank you.
- Log in to post comments
Hi Anton, Yes I did, I just tried again and it did work, Thanks. My question was not as descriptive as my for attempt, had to type it out 6 times. Hopefully the info they need is in the system report. there were no minidumps created during the boot process. Today I had an E-Sata 2T drive connected during boot and couldn't get past the snapman.sys blue screen=> stop: 0x0000007E (0xFFFFFFFFC0000005, 0xFFFFF88001FB409C, 0xFFFFF880009A9458, 0xFFFFF880009A8CB0)
snapman.sys - address FFFFF88001FB609C base at FFFFF88001F9B000, datestamp 5024D0DC
after switching the drive off I managed to boot, could this be a clue? it was connected through the boards 2nd controller JMicron JMB36X Controller I have 2 IDE drives connected through the same. Not sure if any of this helps.
Pat L I tried cleanup of TI2013 and Plus but didn't help first reboot after install bluescreen on boot
Regards Rob
- Log in to post comments
Hello Rob,
Thank you for your response.
I am sending a file to you via Private messages, please install it and see if the issue remains.
If the issue still persists, please obtain kernel or full dump file, we can't investigate the issue without a dump file:
Thank you.
- Log in to post comments
I have been supplied with an updated snapman.sys from Oleg (Acronis) and all seems to work correctly. Thanks for prompt support.
Rob
- Log in to post comments
Rob,
You are welcome. We are glad to hear that the issue has been resolved.
Thank you.
- Log in to post comments