Clone linux disk

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 3
Comments: 3

Hi, I tried a week ago to clone a linux Ext3 hard drive with Acronis Backup and Recovery: Advanced Workstation Linux boot media. I went to Disk Management, right clicked on the Source disk (partition type was labeled as Unsuported even though I used the Linux boot media), selected Clone basic disk, and selected the destination disk. The operation started off with 50% bar, and then the operation status changed to "Failed".

How do I clone an Ext3 (or other linux partitions) with Acronis Backup and Recovery?

Thanks!

Wed, 02/23/2011 - 00:14
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Posts: 27
Comments: 1940

Back it up and then recover on the target. The trick is that nowhere in the userguide filesystems that Disk Management supports. "Acronis Backup & Recovery 10 can back up and recover the following file systems" is about 'backup and recover', not disk management.

Wed, 02/23/2011 - 07:54
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 3
Comments: 3

Does the advanced server media behave in the same way, where on the fly clone can not be achieved?

Thanks!

Wed, 02/23/2011 - 16:08