Offline Activation state gets lost in Company Network
Once I've activated the license offline succesful, the message activation required appears when I'm in the Office and connecting to the Network.
Isn't there an entry in Config or registration files that keeps the state in activated, once it has been done offline?
Thanks in advance and regards


- Anmelden, um Kommentare verfassen zu können

Have the same issue when using the off-line activation as well as will not active online too on 3 pc's
Offline, if you go to web site upload your activation file and download the licence file it creates and then use the offline activation to add this to your PC. It looks fine, however it then drops back to activation back to the 30 days.
I have tried removing 2018 and using the cleaning tool and removed left over folders and any reg entries and have the same issue.
One thing I've yet to try is block license_activation.exe in the firewall and then try a offline activation.
%ProgramFiles(x86)%\Acronis\TrueImageHome\license_activator.exe
Also have a support ticket & still wait for information other than type in your licence code from them.
- Anmelden, um Kommentare verfassen zu können

@Steve: Thanks, Support is allready involved.
- Anmelden, um Kommentare verfassen zu können

Good news support has fixed the issue.
Good work guys at Acronis Support.
- Anmelden, um Kommentare verfassen zu können

@ Moss: Sounds great, I'm still waiting. Do you have some details?
- Anmelden, um Kommentare verfassen zu können


Yong Ra, if you have this problem with activation, then please raise a Support Ticket for it.
- Anmelden, um Kommentare verfassen zu können

@Moss Are you able to share the solution they gave you?
I have the same issue while connected to the corporate network. Basically offline activation succeeds if I disconnect the network cable, but Acronis reverts to "activation required" on subsequent restarts of Acronis with the network cable connected (see Attached word doc). I've repeated this several times. So a network connection failure results in reverting the activation status :-( I just completed a chat session with support, and sending them the required followup/support info. Based on the output of http://dl2.acronis.com/u/kb/AcronisCloudUS2Check.exe it appears the cause might be port 44445 blocked by the corporate firewall (my local firewall is off for testing this), I thought it might be lack of web-proxy support.
I only need to use Acronis on this system for local disk to disk backup (no cloud backup). It is quite frustrating that the activation doesn't stick. I am software engineer and work on network management products, so extra dissapointing to see a basic license/activation check flaw like this.
Anhang | Größe |
---|---|
430310-140089.docx | 173.69 KB |
- Anmelden, um Kommentare verfassen zu können