ATI 11 after cloning invalid system disk
I'll start off by saying this is the last version I'll buy. I've had minimal success at all my endeavors using this product. I don't use it on a regular basis, so each time is a learning curve.
Anyway, this time I needed to buy a new HDD due to my 250GB being nearly full. Setup a new 750GB (both SATA btw). Mistake #1 was not creating a TI recovery CD.
The cloning process did its job, but upon booting after the completion I get an "invalid system disk" message. I remove the old HDD and move the SATA cable from old HDD to new one, same problem.
Ok, I'll pop in the Visat 64 DVD and recover... right? No. get a message saying versions are different *HUGE SIGH* come here nad browse 30 minutes trying to find a resolution or a problem even close. No go.
So instead of spending days awaiting ATI support on an older product (doubt if they'll even talk to me) I decided just to re-install windows and rebuilt the HDD... Faster than trying to use this product and its tech support.

- Anmelden, um Kommentare verfassen zu können