Salta al contenuto principale

ATI 11 after cloning invalid system disk

Thread needs solution

I'll start off by saying this is the last version I'll buy. I've had minimal success at all my endeavors using this product. I don't use it on a regular basis, so each time is a learning curve.

Anyway, this time I needed to buy a new HDD due to my 250GB being nearly full. Setup a new 750GB (both SATA btw). Mistake #1 was not creating a TI recovery CD.
The cloning process did its job, but upon booting after the completion I get an "invalid system disk" message. I remove the old HDD and move the SATA cable from old HDD to new one, same problem.

Ok, I'll pop in the Visat 64 DVD and recover... right? No. get a message saying versions are different *HUGE SIGH* come here nad browse 30 minutes trying to find a resolution or a problem even close. No go.

So instead of spending days awaiting ATI support on an older product (doubt if they'll even talk to me) I decided just to re-install windows and rebuilt the HDD... Faster than trying to use this product and its tech support.

0 Users found this helpful

Next time, before you leap, maybe see if my guides can help. Check the index in my signature below.