TI 2010 plus pack - no universal restore prompt
I performed 2 backups: one of the source system partition and of of the target system partition.
Booting the target pc using the standard Acronis bootable disk created after installing the plus pack I get the following result:
- trying to restore the target system partition I could prompt "universal restore"
- trying to restore the source system partition - as desired - I could NOT prompt "universal restore".
Any hint?
Thanks, Thomas

- Anmelden, um Kommentare verfassen zu können

I only did a backup of the target system to be able to recover this in case the universal restore of the source system on the target system does not work - and it did not work.
I just wanted to point out that following the general guideline of Acronis how to use TI 2010 plus pack for universal restore does not work - in the forum there is a comparable issue described using Backup & Restore 10 - Acronis states this to be a gui issue and solved it by a patch.
- Anmelden, um Kommentare verfassen zu können