Linux Boot Image: don't have all network interfaces
Hello,
I created a bootable iso via the acronis media builder (type: Linux-Based, Linux-like representaion). For a restore, I need a network connection but after booting the iso image, I only get 2 interfaces instead of 4.
I am running RHEL4 on the server and following modules are loaded e1000 and bnx2:
03:00.0 Ethernet controller: Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet (rev 11)
06:00.0 Ethernet controller: Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet (rev 11)
1c:00.0 Ethernet controller: Intel Corporation 82571EB Gigabit Ethernet Controller (rev 06)
1c:00.1 Ethernet controller: Intel Corporation 82571EB Gigabit Ethernet Controller (rev 06)
When booting via the iso image, I only have eth0 and eth1 (interfaces created for the intel ethernet controllers).
How can I debug this?
Thanks.
Regards,
Dirk

- Se connecter pour poster des commentaires