ATI 2016 build 5586 : backup & cloning error
Hi,
I just installed ATI 2016. when I try to define a backup, I select "disks and partitions" as backup source.
however nothing shows up in the window where my disks / partitions should be visible.
Another thing, maybe related : when I go to "tools" > "clone disk" I get the following error (see attachment)
Any idea ?
Thanks !
Johan
Fichier attaché | Taille |
---|---|
ati2016_error.jpg | 45.4 Ko |


- Se connecter pour poster des commentaires

Hi Ian,
yes, I searched the KB but found nothing really related to the issue(s)
I'm using Win 10 64 PRO
Win 10 is a fresh install. I used to have win 7 on an SSD. I added an extra SSD where I did a clean install of win 10.
ATI 2016 is also a new installation.
On my win 7 system I used Acronis True Home 2011.
When I launched ATI2016 on win 10 , it detected the old ATI2011 backup definitions on my win7 SSD. But I don't think this would cause the strange behaviour of ATI2016 ....(I hope)
When I choos e "folders" as backup source, I can see the folders on my system. Also, choosing a "target" is also possible, I can see all the disks in my system.
Thanks for your help
regards
Johan
- Se connecter pour poster des commentaires

Hello Johan
I would recommend you to contact our Support team to investigate the issue: https://www.acronis.com/support/
Please, sent also a feedback to our development team from the product with System Report attached: http://www.acronis.com/en-us/support/documentation/ATI2016/#33003.html
Thank you,
- Se connecter pour poster des commentaires