Try and decide isn't working properly
Hello,
I purchased today Acronis TI 2017 and i wanted to see how everything is working, but Try&Decide isn't working properly
I did some tests, but after i choice DISCARD ( during reboot ) is not working properly, some settings are from earlier then i selected Try&Decide
Could you please help me to fix this issue ?
Thank you

- Se connecter pour poster des commentaires

I would contact technical support and open a case direclty with them. I've never used try & decide as it seems to be a mixed bag depending on the system bios settings and can be complicated by other things like using Acronis startup recovery manager or Acronis secure zone in conjuntion. I suspect you'll be asked to trouble shoot and provide a system report and other logs for review. Open a support case, via chat to get it going...
http://www.acronis.com/en-us/support/contact-us.html
- Se connecter pour poster des commentaires

Hello Attx,
Please verify that when starting Try&Decide, you mark all the partitions that you would like to monitor. By default just 1 partition is protected.
Also see the limitations that Try&Decide feature has: http://www.acronis.com/support/documentation/ATI2017/index.html#299.html (scroll down to the Limitations section). One of them is inability to track and revert properly the disk structure.
If the issue persists, you can open a support ticket, as Bobbo suggested.
Regards,
Slava
- Se connecter pour poster des commentaires