Rescue media, and format [Add Disk] it, or will have problems on booting because cloned from c:/ and has the same signature

If I wanted --- Connect an SSD [D:/ or Z:/] Disk to Windows 10 Pro PC, with the same signature [cloned from C:/] as for C:/ SSD, I want to format this Z:/ as failure is...
Can boot to Acronis TI 2018 Rescue media, and format [Add Disk] it, or will have problems on booting because cloned from c:/ and has the same signature???
In other words, when boot to Acronis DVD Media --- this done before this creates problems of the same signature... DISKS,...??


- Se connecter pour poster des commentaires

Is very difficult to remove SSD from PC
If I leave it, connect it to SATA internally...
and boot to Acronis media -- should be a problem for sure or Not...?
- Se connecter pour poster des commentaires

What internal disk drives are installed in this PC and what type of drives are they, how are they connected?
Which disk is being used to boot into Windows on this PC?
- Se connecter pour poster des commentaires

2 x 1TB SATA SSDs
1 x 4TB SATA HDD
TO DISCONNECT A SATA internal DRIVE
REQUIRED POWER CABLE DISCONNECTED
OR CAN LEAVE CONNECTED POWER cable AND DISCONNECT DATA sata cable ONLY CABLE....?
- Se connecter pour poster des commentaires

You can disconnect the drive power cable and check that the drive is no longer shown in Windows disk management or Explorer.
It may be best to disconnect both power and data cables for 100% safety if intending to reformat one of the other drives - that way no mistakes can be made! Just tie the disconnected cables together and label them to avoid connecting back to a wrong drive later.
- Se connecter pour poster des commentaires

So, after connecting/disconnecting cables SATA,
I CAN BOOT from
Acronis TI 2018 DVD Rescue Media and "Add Disk", GPT/UEFI... correct?
- Se connecter pour poster des commentaires

Yes
- Se connecter pour poster des commentaires