TrueImage 10 Win 7 32bit Clone
I'm trying to clone a windows 7 32 bit drive, the cloning proccesss completes normally but when I try to boot from the cloned drive I am getting the following error.
Windows failed to start
Status: 0xc000000e
Info: The boot selection failed because a required device is inaccessible.
I tried two different brand new drives and still get the same error.

- Se connecter pour poster des commentaires

I'm Usung Acronis True Image Home 10
- Se connecter pour poster des commentaires

If I upgrade to 11 will it work with Win 7?
- Se connecter pour poster des commentaires

Michael:
Your clone made with version 10 should work, but version 10 does not automatically correct the Windows 7 BCD. But you can do it manually. Boot the PC from a Windows 7 DVD and try the automatic repair. You may need to run the repair more than once.
- Se connecter pour poster des commentaires

Anyone have an answer to this??
If not I need to switch Imaging software..
ASAP
Thanks
- Se connecter pour poster des commentaires

I am doing alot of drives , so I do not have the time to run repair on each drive, If I upgrade to 11 will it work properly?
Thank You!
- Se connecter pour poster des commentaires

TI 2011 will work with WIN 7. I suggest you read http://forum.acronis.com/forum/3426 section 3CC.
- Se connecter pour poster des commentaires
