Anyone else having problems with True Image 2019?
I did an upgrade a few days ago on Windows 10 machine that I had recently reset
Everything else I've loaded is working fine, but when attempting to clone my C drive I can't get past the 'Select target disk' section. I get the Acronis spinning circle and then nothing.
I ran a repair this morning, but no change. It's still not functioning as previous editions have.
Anyone else having a similar issue? Thanks.
https://downloader.vip/rufus/ https://downloader.vip/mapquest/ https://downloader.vip/uptodate/


- Accedi per poter commentare

Have you performed a Restart of the machine? A Restart is different than a Shutdown and then power on in Windows 10.
If you have not selected restart since upgrade or install of the Acronis application I suggest you do so. There are times when the application may have problems locking the source disk you are working with thus the behavior you see.
- Accedi per poter commentare

I bought a WD RAID where a cut down version of Acronis was packaged with the product. Unfortunately, this version didn't allow me to specify individual folders to save etc. So I decided to buy the full version. Well I have never used such an unreliable, slow and problematic useless piece of software ever!
- Accedi per poter commentare

Carlton, you've posted this to the ATI 2019 forum. If you have just bought the full version, which one was it? If you have the ATI 2021 version, there is a lot of cyber protection also included and maybe it is just a matter of getting it configured.
Perhaps a posting to the forum for the version you have with a question will help get you running better.
- Accedi per poter commentare