Salta al contenuto principale

BartPE Plugin for TI 2009 Will Not Install-previous TI 12 required

Thread needs solution

 Cannot use the BartPE installer TrueImage2009Addons_s_en.exe
The installation is interrupted and the report indicates that TI Home 12.0.9809 must be previously installed. I have never owned TI ver.12. My TI 2009 was purchased as an upgrade of TI ver.11
I am keen to use my new BartPE USB that was painstakingly created recently. Would be great to get to use TI with Bart.

What to do??
I am attaching a snip of the installer report window after failure...

-regards.

Allegato Dimensione
acronis.PNG 52.54 KB
0 Users found this helpful

Are you using the latest build for 2009? The error message would seem to indicate that your current build is not the most current for 2009. The addons are tied to the matching build. Download the current 2009- 9809 and install it over the top of your current install. Then try reinstalling the BartPE. V12 is the original never used name for 2009 version.

Yes, I am using the latest build #9809 of TI 2009. Thank you for that information:
 "V12 is the original never used name for 2009 version."

It allows a bit more clarity as to what the nature of this problem may be. I looked about the TI Home forum but cannot see anything just like this. The TI 2009 is up to date as I assume the Bart installer is.

I shall keep fingers crossed for more help here. Thank you much for your reply.
-Randy

o.k. I found the solution. The addons(BartPE+) installer worked fine after I used the TI 2009 installer to "modify" my install by adding the rescue media builder. I didn't need that feature on original install. Would be nice to see a note on the rescue media install when the addons installer balks!

-nice to have TI 2009 on BartPE.

But I can't see the hard drives using BarPE on the laptops here. But that's for a Bart forum...